Search the Community
Showing results for tags 'op: tonyd'.
Found 3 results
-
After adjusting ASROC drop distances of torps to target we looked at the distance actually dropped and the torps position immediately after drop. We observed the torpedo was always dropped directly on the sub or 0nm away and also the torps were instantly at the depth of the sub. This was regardless of level of detection or lock on the sub. This gave the sub no warning of a drop on them by ASROC and no time to react or any sensor check might be too long for a detection. I was thinking perhaps a adjustment on flight time might increase the drop distance to the sub a bit and If needed adjustment to torpedoes acquiring depth instantly on drop. Helicopter drops have to start at shallow and make their way down. I have a scenario with a player-controlled sub moving towards a ASROC armed ship at cruise speed and deep. The sub also is active to enhance detection by the ship. The sub will close to 12 nm when ASROC fires at sub. Helicopters are launched by AI on sub too but do not close in time to attack sub prior to ASROC attack. I have attached a test scenario with two saved games one second prior to ASROC launch and two save games prior to torpedo drop. I have also included both message log and GE log collected for the save games. Logs label 2 or for the torpedo drop while the other is for the ASROC launch.ASROC.zip
-
recently while works was done with future data base It was notice on the base selection popup almost all bases only highlighted Blue for Named bases and Red for almost all ZZdonotuse base. It did not matter which color was selected for base creation. The create a base popup determined the color of the base created regardless of the country base popup's color. In short if you selected create red base in pop up screen and chose the only available blue base listed that you wanted it would still be a red base upon selection. This happened with ZZdonotuse red labeled bases if create blue base was selected. The base would be a blue base. It seems only to happen to DB 17909. Attach is the images during the process used. The first image is creat a base which red is red. The second image show a blue base Bejing selected but a red base Bejing is created. The reverse happens if create a blue base is selected and a red ZZdonotuse base is select it will become a blue base. SE version 2022.008 by me and Eric had same result while Ralf using 2022.005 was the first to notice the issue. ZZ
-
Hey TonyE I was trying to make a map for the possible new Battleset. I have had on and off luck with it but lately all I get when trying to produce it is this error and then have to close the creator with Task Manager. Attached is the screen shot I get. TonyD
